Talking about the matters needing attention when pouring the foundation of solar street light solar street light

1. Determine the position of the standing lamp; investigate the geological conditions, if the surface 1 m 2 is all soft soil, the excavation depth should be deepened; at the same time, it should be confirmed that there are no other facilities (such as cables, pipes, etc.) below the excavation position, and the top of the street lamp is not long. Time to shade the object, or change the position appropriately. 2. Reserve (excavate) a pit that meets the standard at the position of the vertical lamp (design depth according to the height of the lamp pole); carry out the positioning and pouring of the pre-embedded parts. The embedded parts are placed in the center of the square pit, one end of the PVC threading pipe is placed in the center of the embedded parts, and the other end is placed in the battery storage place. Pay attention to keep the embedded parts, the foundation and the original ground on the same level (or the top of the screw is on the same level with the original ground, depending on the needs of the site), and one side should be parallel to the road; only in this way can the rear end of the light pole be erected and Not skewed. Then it is fixed with C20 concrete. During the pouring process, the vibrating rod should not be used to vibrate to ensure the overall compactness and firmness. 3. After the construction is completed, clean up the residual sludge on the positioning plate in time, and use waste oil to clean the impurities on the bolts (the bolts can be wrapped with tape before construction to prevent too many magazines from adhering to it, which will affect the installation progress). 4. During the solidification process of the concrete, it is necessary to water and maintain it regularly; the chandelier can only be installed after the concrete is completely solidified (generally more than 72 hours).