Precautions for the installation of solar garden light batteries and lamps solar street light-litelso

The garden light is an independent self-powered system. When installing the solar maintenance-free battery, it must be handled with care when placed in the control box to prevent damage to the control box; the connecting wires between the batteries must be pressed against the battery After the output line is connected to the battery, it is forbidden to short-circuit under any circumstances to avoid damage to the battery. When the output line of the battery is connected to the controller in the utility pole, it must be Through PVC conduit. After completing the above steps, check the wiring of the controller to prevent short circuit, and close the door of the control box when it is normal. The installation of solar garden light fixtures requires the components of each part to be fixed: the solar panel is fixed on the solar panel bracket, the lamp head is fixed on the pick arm, then the bracket and pick arm are fixed to the main pole, and the connecting wire is routed to the control box (battery box). Before lifting the light pole, check whether the fasteners in each part are firm, whether the lamp head is installed correctly, and whether the light source works normally. Then, to check whether the system is running normally, loosen the connecting wire between the controller and the solar panel, the light source works normally, connect the connecting wire of the solar panel and the light turns off; at the same time, carefully observe the changes of the indicators on the controller, so the data belongs to If it is normal, it can be lifted and installed. When the main light pole is hoisted, pay attention to safety precautions, and the screws must be fastened well. If the sun-facing angle of the component is deviated, it needs to be adjusted upwards and its sun-facing direction is completely south. Put the battery into the battery box, connect the cable to the controller according to the technical requirements, connect the battery first, then the load, and then the solar panel; during wiring operations, be sure to pay attention to the different wiring and the terminals marked on the controller. If it is wrongly connected, the positive and negative polarities cannot collide, and cannot be reversed, otherwise the controller will be damaged. Debug the system again to see if the system can run normally; loosen the solar panel connection wire on the controller, the solar garden light is on, connect the solar panel connection wire, and the light is off; at the same time, carefully observe the changes of the indicators on the controller, so If the data is normal, the control box can be sealed.