How to install road lights?

How to install road lights?
1. Determine the installation method of road lights in accordance with the actual environment of the road and the requirements of the designer. Because the lighting fixtures are different, the installation method must be different. Is it like placing it on the top of the column or on the side? After selecting the installation method, it is necessary to adjust the mounting bracket. Then prepare the wires according to the actual length of the lamps. Generally, the length of the wires is about 1 meter longer than the actual length.

2. Turn over the top of the lamp, pass the wire from bottom to top into the column, and connect it with the lamp. The wires at the tail are connected together according to the relevant guidelines in the lamp (generally there are three types of live wire, neutral wire, and ground wire, and it is enough to correspond to each other). After wiring, it can be compacted with tools to ensure that the link will not be broken.

3. Insert the light pole directly into the lead-in hole in the mounting frame, and adjust the angle according to the lighting requirements. After the angle is pulled out, the light pole tower finds the appropriate gear and puts it directly into the bracket tube. After these tasks are completed, the other objects can be installed one by one.

4. If you need to change the bulb, you just need to unscrew the bulb and pull it out of the base to replace it with a new bulb. Pay attention when changing the bulb, the bulb position must be consistent with the gear position in the base. If it is installed incorrectly, it may damage the bulb and shorten its service life.

5. After completing all the procedures, Jiangsu Naite Lighting Electric Co., Ltd. is engaged in the production and design of solar street lamps and high-pole lamps. It has 20 years of solar street lamp production experience and builds the most professional solar street lamp manufacturer. Contact number: 13805257308 . , It must be checked again from the beginning to make sure that all the components have been installed and that they are very stable.