Important components and related requirements of street lights

In recent years, the development of road lights has been rapid, and the quality requirements have attracted more and more attention of the masses. As an important part of street lamps, the quality and opening method of lamps are very important. The material must be aluminum casting alloy, and the thickness must meet the requirements. No cracks or holes in the lamp body are allowed. The buckle part is the top priority. In the past, because of the unreasonable design of the buckle, a large number of lamps were damaged after each strong wind. Therefore, spring buckles should be used on the lamps, two installations, and the upper part of the lamps should be used to open the lamps. Directly open, and important parts such as ballasts are fixed on the lamp body to prevent safety accidents from falling off after the lampshade is damaged. The height of the light pole must be selected according to the road width and usage, the wall thickness must be above 3.5mm, the inside and outside are hot-dip galvanized, the thickness of the galvanized layer is above 35μm, the thickness of the flange is above 18mm, and the flange and the light pole must be welded. Reinforcing ribs to ensure the strength of the bottom of the light pole. In the past, due to the unqualified galvanization of the light pole and the lack of welding reinforcement, the bottom of the light pole was seriously corroded, and the phenomenon of the light pole being blown off by the wind often occurred. Therefore, the wall thickness of the lamp pole, the thickness of galvanizing and whether to add welding reinforcement are important signs of whether the lamp pole is qualified or not, otherwise it cannot be used. The company has obtained the third-level installation qualification and safety license, and customers are welcome to borrow and cooperate. We are willing to provide customers with high-quality products and solar power system solutions with strong strength, superb technology and perfect service.