Introduction to the performance-related parameters of high pole lights

High-pole lamps are classified as a large-scale high-end lighting product. Due to the high price, customers are very concerned about the length of their service life. After all, it is a device of tens of thousands of yuan. It is still very uneconomical to assume that it will break down after three or five years of use. , So how long is the life of the high-pole lamp? The following is a systematic analysis of the high-pole lamp manufacturer Feilixiang Lighting. The components of the high pole lamp are the main pole, the lifting system, the lamp panel and the lamp head, the hook and the hook. From this, we can intuitively see that only the lamp cap belongs to the electronic product. We are very clear that electronic products are the easiest to cause problems. Main pole of high pole light: The main pole of high pole light with a height of more than 20 meters usually uses a steel plate with a wall thickness of 5.6mm as the main material. The solid level is not inferior to the stability of the whole board. After the whole welding of the high pole lamp is realized, the inner and outer surface layers need to be intermittently hot-dip galvanized. A qualified galvanizing process can ensure that the main pole will not rust within 15 years. This effect will definitely not be achieved, but after all, the wall thickness of the steel is more than 5mm, even if it has been rusted for ten or twenty years, it will not rust badly, so the main pole of the high pole lamp will not be broken, unless Plan to remodel to replace it. Lifting and landing system: The lifting and landing system is a core part of the high-pole light. The up-and-down action of the light panel is completely dependent on the lifting and landing system. The lifting and landing system of the high-pole light is mainly the winch and the wire rope. It can't be broken for years. Why do you say this? First of all, the winch is installed inside the main pole. If the wind is not exposed to the rain, it will definitely not cause the aging of the line. Second, the winch is rarely started. It is assumed that the lamp head light source is 10 years old. If it's not bad, you don't need to touch it for ten years. So it is very difficult to make the up and down system broken. Lamp panel: The function of the high pole lamp lamp panel is to load the light source. The appearance is diverse, there are semi-circular and full-circle double-layer or single-layer, and ten or twenty 250 watts are installed. LED light source. Lamp holder: Let's talk about the lamp holder now, whether it is an LED lamp holder or a low-pressure sodium lamp, they all belong to the light source type. There are many types of light source chips, different chips have different power sources, and the service life is not the same. It's basically invisible from the outside. The light source is the primary marker of the whole set of high pole lights. Since the high pole lights are street lights, the infection of the street lights is to illuminate. When arranging light sources, it is necessary to choose genuine brand names. From the above analysis, we can see that other parts other than the light source are almost indestructible, and here is a special note, that is, it is not recommended to spray the high pole lights intermittently, because the spraying process is slightly worse - such as plastic Poor flour quality or baking temperature too high or too low. These factors will cause the surface of the rod to explode, which does not affect the use but seriously affects the appearance. Assuming that you want to maximize the service life of high pole lights, you can do two things - 1, do not spray plastic, 2 set up equipment to arrange high-end light sources.