Talking about the installation requirements of high pole lights solar street light-litelsolar manufacturers

1. The main rod is formed in one time. The welding seam of the steel rod (Q235) must be smooth and smooth, and the error between the raised part of the welding seam of the whole rod body and the flatness of the rod body should not be greater than ±1mm. The welding method of the lamp pole is automatic argon arc welding, and the coloring flaw detection inspection meets the requirements of the international welding standard GB/T3323-1989111. The socket connection method of the lamp pole is fixed by means of nails and top wires. 2. The anti-corrosion treatment of the lamp pole is hot-dip galvanized, the surface of the galvanized layer is smooth and beautiful, and the gloss is consistent. There is no wrinkled skin, slump and zinc tumor, peeling, half point, yin and yang surface defects, the thickness of the zinc layer is more than 85μm, the adhesion of the zinc layer should meet the GB2694-98 standard, and it is guaranteed not to fade for 8 years, and the wind resistance of the light pole The capacity is designed at 36.9 m/s. The anti-corrosion life of the lamp pole is more than 20 years. 3. The thickness of the sprayed plastic on the surface of the light pole is ≥100μm, the adhesion reaches GB9286-880 level, the surface is smooth: the hardness is ≥2H, the outdoor weather-resistant material is used, and the sprayed material is all polyester plastic powder.